Sony STR-DA5ES Operating Instructions Manual page 68

Hide thumbs Also See for STR-DA5ES:
Table of Contents

Advertisement

Using the lists (continued)
Learning
the commands
of
your components
By using the Learning function, it is possible
for this commander to perform learned
operations.
Setting
remote control
codes that
are not stored in the commander
When a remote control code is not one of the
presets stored in the commander, it is possible
for the commander to learn the code using the
Learning function.
1
Press SET UP and move the easy scroll
key to select "LEARNING",
then press
the key to enter the selection.
The function list appears.
pg?J
2 Move the easy scroll key to select the
function
you want to use the Learning
function,
then press the key to enter
the selection.
The button list appears.
pjr---j
3 Move the easy scroll key to select the
button you want to use for the Learning
function,
then press the key to enter
the selection.
The learning display appears.
4 Point the remote code receiver section
of the commander
toward the receiver/
transmitter
on the remote control to be
learned.
About5cm-15cm
5 Move the easy scroll key to select
"Learning
Start", then press the key to
enter the selection.
"Learning Now!!" is displayed.
6
Press the appropriate
button on the
remote control to send the remote
control code.
Lightly pressing the button once should be
sufficient. In about 3 to 5 seconds, it is
displayed whether learning was successful
or not.
When the learning completes successfully,
"Learning OK!", the number of keys, and
the capacity used for learning are displayed.
yfg&J
When the learning does not complete
successfully, the cause is displayed.
FIj
Information*
* FULL (Keys): shortage of buttons
FULL (memory): shortage of memory
ERROR: other causes
1
68

Advertisement

Table of Contents
loading

This manual is also suitable for:

Str-da3es

Table of Contents