The Set Up Button - Sony STR-DA5ES Operating Instructions Manual
Hide thumbs
Also See for STR-DA5ES:
- Operating instructions manual (96 pages) ,
- Service manual (82 pages) ,
- Technical background (38 pages)
Table of Contents
Advertisement
(STR-DAIES
only)
Two remotes are supplied with STR-DASES
(RM-LJ305, RM-US 105). For details, refer to
the following pages respectively.
RM-LJ305: pages 53-74
RM-US 105: pages 75-8 1
For the remote (RM-PP505L) supplied with
STR-DA3ES, refer to the separate operating
instructions.
Inserting
batteries
into the
remote
Insert three LR6 (size-AA) alkaline batteries
with the + and - properly oriented in the
battery compartment. When using the remote,
point it at the remote sensor m
on the
receiver.
lip
Under normal
conditions, the batteries should last for
about 3 months.
When the remote no longer operates
the receiver, replace all the batteries with new ones.
Notes
* Do not leave the remote in an extremely hot or
humid place.
l
Do not use a new battery with old ones.
l
Do not mix the
alkaline batteries and other kinds of
batteries.
This remote is designed for use with the
alkaline batteries only.
- Do not expose the remote sensor of the receiver to
direct sunlight or lighting apparatuses. Doing SO
may cause a
malfunction.
- If you don’t use the remote for an extended period
of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
Understanding
the 2 way
remote
system
This remote operates under a 2 way remote
system. With the two way remote system, the
component responds to signals sent from the
remote by sending additional signals
(information about the
status
of the component,
text data, etc.) back to the remote. Thus,
operations are performed as a result of
communication between the remote and the
component.
When using a home entertainment system
comprised of several components compatible
with the 2 way remote system, please restrict 2
way remote system operation to a single
component. Normally, turn off the 2 way
remote system on all
components except the
receiver.
2
(D
If you would like to turn off the receiver’s
J
2 way remote system, set “2-way remote”
using
f:
the SET UP button (page 50).
I
The COMMAND
MODE
i.
If the receiver’s COMMAND
MODE
and the
s
remote’s COMMAND
MODE do not match,
transmission is not possible between the remote
z
and the receiver. If you have not changed the
ii
COMMAND
MODE of the remote and the
3
receiver after purchase, it is not necessary to set
8
the COMMAND
MODE. For details, see page
73.
continued
Page 53
Advertisement
Table of Contents
