1
Remove the protective cover of the metal
sheet, and then affix it.
2
Affix the antenna box onto the metal
sheet.
3
Use clamps to secure the antenna cable.
Mount into the dashboard
Note
•
Check wire connection before you mount the unit
into a car.
•
If preset radio stations are lost when the ignition key is
turned off and then turned on, reconnect the red leads
crosswise to the yellow ones.
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that the
bare wires do not touch each other.
b
a
c
2
Ensure that car dashboard opening is
within these measurements:
• Since the unit cannot be used if the
slant angle of dashboard opening is
above 20 degrees, ensure that the
horizontal slant of the dashboard
opening is between 0 and 20 degrees.
3
When installing in a shallow space, change
the position of slide brackets.
4
Place the supplied rubber cushion over the
end of the mounting bolt.
EN
14