EnGenius FreeStyl 1 User Manual page 9

22. Change Pwd
a. Allow changing the handset password which requires to enter in Call
Barring (MENU-4-4) and Menu Display (MENU-8) .
Re:Default is "0000".
23. Change PIN
a. Allow changing the Base PIN which requires to enter in Base
Settings (MENU-6).
Re: Default is "0000".
24. DTMF Duration
a. From MENU-6-1 to select variable duration of DTMF tone.
b. Default is 100ms.
c. When entering the base setting, PIN is required. Default is "0000".
Re: Better to check with your phone company first before changing it.
25. Programmable Flash key timing
a. From MENU-6-2 to select flash key timing
b. 9-level (100 ms - 900 ms) timing selections, default= 600 ms.
c. The default value (600 ms) works in most areas. Changing this
setting may cause Flash key not working. Change only when you
are certain of the new value would work.
d. When entering the base setting, PIN is required. Default is "0000".
26. Assign handset ID for new handset
a. Using registered handset from MENU-6-3 to assign a handset ID to
a new handset.
b. If not assign handset ID, the system will automatically assign a
handset ID to a new handset..
c. When entering the base setting, PIN is required. Default is "0000".
27. Clear Handset
a. Using registered handset from MENU-6-4 to remove the other
registered handset, in case the other registered handset is defected.
b. Once clear the other registered handset, the user is able to register a
new handset for instead.
c. When entering the base setting, PIN is required. Default is "0000".
28. Change PIN
Allow changing the base PIN which requires to enter the "Base Settings"
(MENU-6-5).
a. Using registered handset to change PIN from MENU-6-5.
~17~
b. Default PIN is "0000".
c. When entering the base setting, PIN is required. Default is "0000".
29. Auto Hang Up feature
a. Using registered handset from MENU-6-6 to turn on/off the Auto
hang up feature.
b. If turning on the feature, the handset will automatically hang up the
call when the far-end hangs up the call.
c. When entering the base setting, PIN is required. Default is "0000".
30. Set Time
The set time function allows user to set date/time to support the DTMF
caller ID (DTMF caller ID doesn't attach date/time when receiving from
PSTN, using this setting, user is able to review the date/time when the
caller ID received).
a. Enter MENU-6 to set Base Settings.
b. Enter Base PIN (Default is "0000").
c. Enter "7" to enter Set Time.
d. Enter 4 digits for MM/DD(Month/Day), then enter 4 digits for hr:mm
(Hour：Minute)
e. Press SAVE (left soft key) to finish the setting.
~18~