McIntosh MX121 Owner's Manual page 20

Audyssey Parameter Check
®
An error message is displayed if the Audyssey Auto
Setup could not be completed due to speaker place-
ment, the measurement environment, etc. If this hap-
pens, check the relevant items, make any necessary
corrective measures, then perform Audyssey Auto
Setup over again.
20
On-Screen Display
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ XT
Caution!
No microphone or Speaker
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ XT
Caution!
Ambient noise is too high
or Level is too low
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP
MultEQ XT
Caution!
Front R None
Retry
RETURN Cancel
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ XT
Caution!
Front L Phase
Retry
Skip
RETURN Cancel
Check cause of problem!
Error Details
The connected setup microphone
is broken, or a device other than
the supplied setup microphone is
connected.
Not all speakers could be detected.
The front L speaker was not prop-
erly detected.
There is too much noise in the
room for accurate measurements to
be made.
Speaker or subwoofer sound is too
low for accurate measurements to
be made.
The displayed speaker could not be
detected.
The displayed speaker is connected
with the polarities reversed.
Corrective Measures
Connect the included setup microphone to
the SETUP MIC jack of this unit.
Check the speaker connections.
Either turn off any device generating
noise or move it away.
Perform again when the surroundings are
quieter.
Check the speaker installation and the
direction in which the speakers are facing.
Adjust the subwoofer's volume.
Turn off the power before checking
speaker connections.
Check the connections of the displayed
speaker.
Check the polarities of the displayed
speaker.
For some speakers, this error message
may be displayed even if the speaker is
properly connected. If you are sure the
 
connection is correct, press to
select "Skip", then press ENTER.