Table of Contents
Advertisement
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 103.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 104.
4. Note the location of the four screws
assembly upward.
Figure 70. Pivoting the drive bay assembly
5. Hold the hard disk drive and remove the four screws that secure the hard disk drive. Then, remove the
hard disk drive from the drive bay assembly and disconnect the signal cable and the power cable from
the rear of the hard disk drive to completely remove it from the chassis.
1
that secure the hard disk drive. Then, pivot the drive bay
.
Chapter 9
Replacing FRUs (Machine Types: 0804, 0809, 0811, 0822, 0825, 0828, 0830, 0833,
0837, 0843, 0845, 0847, and 0849.)
127
Advertisement
Table of Contents
