Table of Contents
Advertisement
Figure 29. Installing the hard disk drive
7. Connect one end of the signal cable to the rear of the new hard disk drive and the other end to an
available SATA connector on the system board. See "Locating parts on the system board" on page 71.
Then, locate an available five-wire power connector and connect it to the rear of the new hard disk drive.
Figure 30. Connecting a SATA hard disk drive
8. To complete the installation or replacement, go to "Completing the parts replacement" on page 96.
Replacing the front audio and USB assembly
Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the front audio and USB assembly.
To replace the front audio and USB assembly, do the following:
.
Chapter 8
Replacing FRUs (Machine Types: 0806, 0810, 0821, 0823, 0827, 0829,0832, 0835,
0842, 0844, 0846, 0848, 0851, and 4089.)
93
Advertisement
Table of Contents
