Table of Contents
Advertisement
Figure 68. Installing the optical drive
11. Connect one end of the signal cable to the rear of the new optical drive and the other end to an available
SATA connector on the system board. See "Locating parts on the system board" on page 71. Then,
locate an available five-wire power connector and connect it to the rear of the new optical drive.
Figure 69. Connecting a SATA optical drive
12. To complete the replacement, go to "Completing the parts replacement" on page 131.
Replacing the hard disk drive
Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive, do the following:
126
ThinkCentre Hardware Maintenance Manual
Advertisement
Table of Contents
