Installing Or Replacing A Memory Module - Lenovo ThinkCentre 0804 Hardware Maintenance Manual

Hide thumbs Also See for ThinkCentre 0804:
Table of Contents

Advertisement

Figure 46. Installing the PCI card
6. If necessary, connect any cables between the PCI card and the system board. See "Locating parts on
the system board" on page 101 to identify the various connectors on the system board.
7. To complete the installation or replacement, go to "Completing the parts replacement" on page 131.

Installing or replacing a memory module

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to install or replace a memory module.
Your computer has two memory slots for installing or replacing DDR3 SDRAM DIMMs that provide up to a
maximum of 4 GB of system memory. When installing or replacing a memory module, use 1 GB or 2 GB
DDR3 SDRAM DIMMs in any combination up to a maximum of 4 GB of system memory.
To install or replace a memory module, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 103.
3. Lay the computer on its side for easier access to the system board.
4. Locate the memory slots on the system board. See "Locating parts on the system board" on page 101.
5. Remove any parts and disconnect any cables that might prevent your access to the memory slots.
6. Do one of the following:
• If you are replacing a memory module, open the retaining clips and remove the old memory module
that is currently installed.
Figure 47. Removing the memory module
• If you are installing a memory module, open the retaining clips of the memory slot into which you
want to install the memory module.
.
Chapter 9
Replacing FRUs (Machine Types: 0804, 0809, 0811, 0822, 0825, 0828, 0830, 0833,
0837, 0843, 0845, 0847, and 0849.)
109

Advertisement

Table of Contents
loading

Table of Contents