Sense[1] Subsystem - Keithley 7706 User Manual

:DIGital
:BYTE <nrf>,<clist> — Use to force the digital output of the given channel[s] to the desired value (0 < × < 255) in decimal
format. Use this command to write to Channel 21 or 22 individually. Bit 0 of each port is the LSB.
:BYTE? <clist> — Query the present bit pattern (0 < × < 255) for the digital output channels (returned in decimal format). Use
this command to query Channel 21 or 22 individually.
:WORD <nrf>,<clist> — Must write to the lower port (channel 21). Channel 21 bit 0 will be the LSB and Channel 22 bit 7 will
be the MSB.
:WORD? <clist> — Query the present bit pattern (0 < × < 65535) for the digital output channels (returned in decimal format).
This command must be sent to Channel 21.

SENSe[1] Subsystem

Commands to perform Model 7706 specific operations are listed in
Table 5
Sense1 subsystem commands
Command
:SENSe[1]
:TOTalize
:TYPE < READ | RRESet >,<clist>
:TYPE? <clist>
:EDGE < RISing | FALLing >,<clist>
:EDGE? <clist>
:DATA? <clist>
Channel list parameter:
<clist> = (@SCH)
where: S = Mainframe slot number (1 or 2); CH = Switching module channel number (must be 2 digits);
Examples:
(@101) = Slot 1, Channel 1
(@101, 203) = Slot 1, Channel 1 and Slot 2, Channel 3
(@101:110) = Slot 1, Channels 1 through 10
Table 5.
Description
Path to the :SENSe[1] commands.
Path to configure 7706 Totalizer.
RRESet (read and reset) causes the Totalizer count to be
reset to zero every time it is read.
Query Totalizer count readback type.
Set which edge of the input signal to count.
Query trigger edge for the Totalizer.
Query the current Totalizer count. This command will reset
the count to 0 if TOT:TYPE is set to RRESet.
Bus commands
Default
READ
RIS
29