Installing The Canopy Housing - Fanimation Islander MAD3250 Series Owner's Manual

NOTE: This step is applicable after the necessary wiring
is completed.
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed (Figure 14a).
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature (Figure 14b).
Assembling and Mounting the Fan Blades Assembling and Mounting the Fan Blades
1. Lay flat side of blade holder arm on a flat surface
with the inside of the blade holder arm facing up.
This is the side with the threaded posts and pitched
foot. Position the blade over the blade holder with
the threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
holder arm. Place blade holder cover on top of the
blade, positioning the holes over the threaded posts.
With a Philips screwdriver, thread both screws into
the posts but do not fully tighten.Prior to final
tightening, position the centerline of the blade holder
with the center of the end of the blade. Tighten both
screws to secure the blade. (Figure 15)
NOTE: You will find the fan blade set packed in its own
carton and the blade holders and hardware bag in the
fan box.
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.

Installing the Canopy Housing

Figure 14a
Blade Holder Cover
HARDWARE USED:
3/16-24 x 7.5mm
PHILLIPS HEAD
SCREWS
9
Figure 14b
Blade Holder
Figure 15
x 10