Disassembly - Greenlee 773 Instruction Manual

Disassembly

This tool consists of three subassemblies: the cutter
head, stationary handle, and movable handle sub-
assemblies (see figure).
1. Cutter head assembly: movable blade (1), stationary
blade (2), release lever (3), links (4), spring cover
(10), reverse lever pin (12), spring (37), bushing (29),
return spring (36), shoulder screw (17) and related
hardware.
2. Stationary handle assembly: handle unit (39), handle
plates (5), holding pawl (6), torsion spring (40),
shoulder screw (16) and related hardware.
3. Movable handle assembly: handle unit (38), handle
plates (8 and 9), speed pawl (11), spring (35), drive
pawl (7), shoulder screws (13 and 16) and related
hardware.
The disassembly procedure is divided into sections of
the tool. Disassemble only the section(s) necessary to
complete the repair.
Disassemble the tool on a flat, clean surface. Take care
not to lose or damage any parts that may fall free during
disassembly.
17
16
Greenlee / A Textron Company
773 and 774 Ratchet Cable Cutters
Cutter head
1. Open the movable blade to release tension on the
2. Remove two shoulder screws (16) and remove the
3. Remove shoulder screw (17), spacers (27 and 20),
4. Remove screw (15) and separate cover (10) from
5. Remove screw (41) and spring (36).
Stationary handle
6. Remove shoulder screw (13) and movable handle
7. Remove two screws (30) and stationary handle
Movable handle
8. Remove two screws (31), left handle plate (8), right
cutter head
assembly
13
stationary handle
assembly
8
blade return spring (36).
cutter head assembly from the handle assemblies.
Note: Holding pawl (6), torsion spring (40), drive
pawl unit (7), washer (22) and spacer (19) may fall
free during disassembly.
links (4), release lever (3) and bushing (29).
stationary blade (2).
assembly.
plates (5).
handle plate (9), speed pawl (11) and spring (35).
movable handle
assembly
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070