Makita AG125 Instruction Manual page 5

.Never use the tool with other than compressed
air. If bottled gas (carbon dioxide, oxgen, nitro-
gen, hydrogen, air, etc.) or combustible gas
(hydrogen, propane, acetylene, etc.) is used as
a power source for this tool, the tool will explode
and cause serious injury.
.Always check the tool for its overall condition
and loose screws before operation. Tighten as
required.
Make sure the safety system is in working order
before operation. The tool must not operate if
only the nail guide is pressed against the wood.
Test for possible faulty operation with nails un-
loaded and the adjuster set to the number
1.
Check walls, ceilings, floors, roofing and the like
carefully to avoid possible electrical shock, gas
leakage, explosions, etc. caused by striking live
wires, conduits or gas pipes.
COMPRESSED
AIR
Gas
pipe Live wire
c