Makita AG125 Instruction Manual page 11

Selecting nails
CAUTION:
Do not drive hardened steel nails or stainless steel nails into concrete or steel plate. If you do so, the
nailer may be adversely affected.
Always check the size of the nail head with the gauge on
1
the
nail guide before loading the nailer. Different size nails
may be mixed up in the nails you purchase locally.
Do not use nails with a head size larger than D 1 or smaller
than D2. Nails with a head size larger than D1 cannot be
inserted into the nail guide. Nails with a head size smaller
than D2 may move into the contact arm and cannot be
driven.
Nail guide
D1
D2
Gauge
I
Loading nailer
CAUTION:
Be careful not to touch the trigger when loading the nail.
*When loading nail into the nailer, grip the nail by the shank, not the tip.
Hold the nail shank lightly and insert the nail head into the
nail guide until the nail is held firmly by the magnet.
Nail
Nail
Magnet
1
Nail
I
Nail guide Contact arm
Adjusting depth of nailing
CAUTION :
Always disconnect the hose before adjusting the depth of nailing.
To adjust the depth of nailing, turn the adjuster so that the
arrow above the adjuster will point to the number indicated
on the adjuster. The depth of nailing is the deepest when
the arrow points to the number 1. It will become shallower
as the arrow points to higher number. The depth can be
changed in approx. 1.5 mm (1/16") increments per gradua-
tion. If nails cannot be driven deep enough even when the
arrow points
to
the number 1, increase the air pressure.
Adjuster
11