Related Manuals for Makita AN504
Summary of Contents for Makita AN504
- Page 1 INSTRUCTION MANUAL Construction Coil Nailer AN504 005711 IMPORTANT: Read Before Using.
-
Page 2: Specifications
EC Declaration of Conformity to EN792: Makita Corporation responsible Sound pressure level (L ) : 82 dB(A) manufacturer declare that the following Makita Sound power level (L ) : 95 dB(A) machine(s): Uncertainty (K) : 3 dB(A) Designation of Machine: Construction Coil Nailer Wear ear protection Model No./ Type: AN504... -
Page 3: Important Safety Instructions
• Tomoyasu Kato Always assume that the tool contains Director fasteners. Makita Corporation Do not point the tool toward yourself or 3-11-8, Sumiyoshi-cho, anyone whether it contains fasteners or not. Anjo, Aichi, 446-8502, JAPAN Do not activate the tool unless the tool is placed firmly against the workpiece. - Page 4 • − fitting transportation safety systems e.g. on Makita. vehicles and wagons. Ask Makita's Authorized service centers for • Do not permit those uninstructed to use the tool. periodical inspection of the tool. • Make sure no one is nearby before nailing. Never To maintain product SAFETY and RELIABILITY, •...
-
Page 5: Installation
CAUTION: INSTALLATION Low air output of the compressor, or a long or • smaller diameter air hose in relation to the nailing Selecting compressor frequency may cause a decrease in the driving capability of the tool. Lubrication L/min 004295 To insure maximum performance, install an air set (oiler, regulator, air filter) as close as possible to the tool. -
Page 6: Loading Nailer
To adjust the depth of nailing, turn the adjuster. The depth claw and are not bent. Then close the magazine cap. of nailing is deeper when turning the adjuster to the 1. Slot symbol side on the tool. It will become shallower when 2. -
Page 7: Air Exhaust
Nailing mode change and trigger locking method 1. Trigger 1. Change lever 2. Contact element 2. Continuous 3. Workpiece nailing 3. Trigger lock 4. Intermittent nailing 005719 Pull the trigger first and then place the contact element against the workpiece. No. -
Page 8: Maintenance
exposed to direct sunlight. CAUTION: Always lock the trigger, disconnect the hose and • remove the nails from the magazine before cleaning a jam. When the nailer becomes jammed, do as follows: Humid Open the magazine cap and remove the nail coil. Insert a small rod or the like into the ejection port and tap it with a hammer to drive out the nail jamming from the ejection Nail... - Page 9 005731 005727 Iron dust that adhere to the magnet can be blown off by Entering dirt or foreign matter into the tool may cause using an air duster. damage to the tool. Make sure that the trigger is locked when the change 1.
-
Page 10: Optional Accessories
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Nails • Air hoses • Safety goggles •... - Page 12 Makita Corporation Anjo, Aichi, Japan www.makita.com 884556C225...