Salt Indicator; Bypassing The Salt Indicator Lamp - Miele G 605 Operating Instructions Manual

Salt indicator.

When the salt reservoir is empty, the
"Salt" indicator lamp will light, notifying
you that the reservoir should be refilled
with reactivation salt.
Note:
If the water used is very soft (below
4 gr/gal), the salt indicator lamp will
stay on. In this case the reservoir
should not be filled with salt. The indica-
tor lamp will remain lit and can be disre-
garded or bypassed.
Water softener (Not available in US models.)
Bypassing the Salt indicator
lamp.
In order to bypass the salt indicator
lamp, you will need a screwdriver and
needle nose pliers.
Remove the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
b
right hand side
Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir.
Using the needle nose pliers, first
c
pull the cap
ber, then remove the float
Replace the float chamber cap,
push the chamber back into its up-
right position, and replace the salt
reservoir cap. The indicator lamp
should now remain off.
.
off of the float cham-
d
.
17