Connecting The Led Tv To A Pc; Using Side Av Connectors - Telefunken TFL2262B12 Operating Instructions Manual

• Recorded programmes are split into 4GB
partitions.
• Recorded programmes are stored in the following
directory of the connected USB disk: \DVR\RECS.
All recordings are indicated with a number. A text
(txt) file is created for each recording. This text
file includes information such as broadcaster,
programme, and recording time.
• Timeshifting may be stopped according to USB
device write speed. If the USB device speed is not
enough for video stream bitrate, timeshifting may
be stopped and recording may fail. If HD service
bitrate is greater than 13 Mbp/sec. some freeze can
be seen during timeshifting on both USB disk and
on external HDD.
• Recordings of HD programmes can occupy bigger
size on the USB disk depending on the broadcast's
resolution. For this reason it is recommended
to use USB hard disk drives for recording HD
programmes.
• Do not plug out the USB/HDD during the recording.
This may harm the connected USB/HDD.
• Multipartiton support is available. Maximum two
different partitions are supported. If the disk have
more than two partitions, crash may occur. First
partition of the usb disk is used for PVR ready
features. It also must be formatted as primary
partition to be used for PVR ready features.
• Some stream packets may not be recorded because
of signal problems, so sometimes video may freezes
during playback.
• Record, Play, Pause, Display (for PlayListDialog)
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording
or playback.
• Radio record is not supported.
• The Tv can record programmes up to ten hours.

Connecting the LED TV to a PC

For displaying your computer's screen image on your
LED TV, you can connect your computer to the TV set.
Power off both computer and display before making
any connections. Use 15-pin D-sub display cable to
connect a PC to the LED TV. When the connection
is made, switch to PC source. See Input selection
section. Set the resolution that suits your viewing
requirements. Resolution information can be found
in the appendix parts
PC Input
(back)
Side AV Input
.
Note: You should use audio inputs of side AV
connection cable (RED & WHITE) to enable sound
connection when connecting a device to your TV by
using PC input.
Note: If you connect a PC to the TV using HDMI
connection, radio interference may occur. Therefore
this type of connection is not recommended. You
should use VGA connection instead.

Using Side AV Connectors

You can connect a range of optional equipment to your
LED TV using side connectors of the TV.
• For connecting a camcorder or camera , you should
use SIDE AV socket (side). To do this, you must use
the supplied video/audio connection cable. First,
plug single jack of the cable to the TV's AV IN socket
(side). Afterwards, insert your camera cable's (not
supplied) connectors into the plural part of the video/
audio connection cable. Colours of the connected
jacks should match. See illustration below.
• Afterwards, you should switch to
the section Input selection in the following sections
for more information.
• To listen the TV sound from headphones, you
should connect headphones to your TV by using the
HEADPHONE jack as illustrated above.
English - 50 -
PC VGA Cable
(Not supplied)
Side Audio/Video
Connection Cable
(Supplied)
PC Audio Cable
(Not supplied)
Side AV source. See
Or