Mitsubishi Electric PK12FK Technical & Service Manual page 58

3 Outdoor unit (PU24EK)
OPERATING PROCEDURE
1. Electrical parts
(1) Remove top panel (3 screws in front, 2 screws in rear).
(2) Remove panel cover (1 screw).
The panel is clasped to the side panel.
Remove by pulling towards you.
(3) Remove service panel (1 screw).
The panel is clasped on the right and left sides.
After removing the screw, pull the panel down and remove it
by pulling towards you.
2. Blower motor
(1) Remove front panel (3 screws).
Open the panel to a 45 degree angle and lift to remove. The
panel is clasped at three points on the left side.
(2) Remove propeller fan (1 set nut).
(3) Remove fan motor (3 screws).
Remove lead connectors.
58
PHOTOS
Screws
Photo 1
Photo 2
Compressor protector
Screws
Photo 3
Motor support
Propeller
nut
Crank case heater
Propeller fan
Panel cover
Run capacitor
52C relay
Terminal block
Separator support place
High-pressure
switch
Valve bed