PSC QuickScan QS2500 Product Reference Manual page 32

NOTE
28
Maximum/Minimum Code Length:
minimum code length, which can be set to qualify data entry. The
length is defined as the actual bar code data length to be sent. Labels
with lengths below the minimum or above the maximum will be
rejected. If the maximum and minimum code lengths are both set to
zero, the global minimum and maximum code length settings are in
effect.
Make sure that the minimum length setting is not greater than the max-
imum length setting; otherwise, all the labels of the symbology will be
unreadable. You can set the same value for both minimum and maxi-
mum length to force decoding of only bar codes of a certain length.
Truncate Leading/Ending:
Same as UPC-A. See page
Code ID Setting:
Insertion Group Selection:
Format: The Full ASCII Code 39, an enhanced set of Code 39, uses a
total of 128 characters to represent Full ASCII code. Each Full ASCII
Code 39 character is a combination of one of the characters +,%, $ and /
with an uppercase alphabetical character (A to Z).
Append: This function allows several symbols to be concatenated and
be treated as a single entry. The QS2500 will not transmit the embedded
appending code (for Code-39, a space). If the append function is
enabled and other symbols are read again with the appended code,
then the codes are transmitted without the code ID, preamble, or pre-
fix. When a symbol was decoded without the appended code, the data
is transmitted without the code ID and prefix, but the postamble suffix
codes are appended. This function is used when the first character of
Code 39 data is a space.
Start/End Transmission:
isks (*). You can transmit all data digits, including the two asterisks.
Each symbology has own maximum and
Same as UPC-A. See page
20
Same as UPC-A. See page
The start and end characters of Code 39 are aster-
.
20
.
.
20
QS2500