Minelab F3 COMPACT Operation Manual page 9

F3 COMPACT Operations Manual
Test Piece – conveniently stowed on the Armrest to allow the
operator to ensure the detector is working at its operational
capability.
Earset Connector – provides connection for the Earset and also
the programming cable when using the configuration software to
customise volume and sensitivity settings.
Main Body – waterproof housing containing the detector electronics
and batteries.
Handle Assembly – collapsible handle that also contains Ground
Balance/Audio Reset button, LED display, LED On/Off button, Noise
Cancel button and Battery Low LED indicator.
Controls – On/Off and Volume/Sensitivity selection knobs – both
controls cannot be accidentally rotated.
Shaft Hinge – pivot point for unfolding or folding the shafts. The
hinge is only locked in position when the Handle Assembly is in its
deployed position.
Upper, Middle, Lower Shafts – carbon fibre shafts that are
adjustable for operator comfort and for changes in demining
positions.
Upper and Lower Camlocks – self-cleaning locking mechanisms to
secure middle and lower shafts.
Coil Pivot Assembly – permits the tilt and rotation of the coil and
provides a tension screw for adjustment as required.
Coil – waterproof enclosed coil to eliminate possible interference
from vegetation; can be rotated 180 degrees. The mono loop design
ensures consistent sensitivity around the entire circumference, and
across the complete surface of the coil.
Skid Plate – removable disk that protects and prolongs the life of the
coil thereby reducing maintenance costs.
7