Messages Relating To Recording - Pioneer PDR-W839 Operating Instructions Manual

9 Additional Information

Messages relating to recording

Message
Can't REC
D.IN UNLOCK
Can't SYNC
CHECK
INPUT ?
REPAIR
REC FULL
Pro DISC
80
En
Cause
The input signal is digital-copy
protected with SCMS.
The digital source was interrupted.
The source is not audio, or is an
incompatible format (e.g. a
CD–ROM).
The digital source is not recognized as
CD, MD, DVD, DAT, or DCC.
The source player was already playing
when the SYNCHRO button was
pressed.
The recorder was switched
off/unplugged after recording without
ejecting the disc. The recorder could
not write essential recording
information onto the disc.
No more recording is possible because
the available recording time of the disc
has been used up, or 99 tracks have
already been recorded on the disc.
The loaded disc is a CD–R or CD–RW
disc for professional use without the
Consumer Use designation.
Remedy
Record the source through the analog
inputs.
Check that the digital input cable is
connected properly and that the power of
the source player is on.
Check that the source is a regular music
source.
If recording from a source other than CD,
MD, DVD, DAT or DCC, try using the
manual digital recording mode.
Stop the source player. After a short time,
SYNC–1 or SYNC–ALL is displayed,
and the recorder goes into synchro–record-
pause mode.
While REPAIR is displayed, the recorder
automatically examines the recorded area
of the disc and updates the track numbers
and recording time data. This process takes
about 40 minutes for a fully recorded disc.
Finalization or further recording is possible
once the REPAIR message disappears.
Use another disc, or erase the
CD–RW disc.
Load a CD–R or CD–RW disc that is
designated as being for consumer use.
Page
p.65-70
p.11
p.70
p.67
p.8