Pontiac Aztek 2003 Owner's Manual page 361

3. Remove the J-hook and the wing nut from the back
of the jack access door. Assemble the wing nut and
the J-hook.
4. Install the wing nut and the J-hook to the D-ring
through the center hole of the tire.
5. Tighten the wing nut to secure the tire to the floor.
Push and pull on the tire to make sure the tire is
secure and does not move.
6. Put back all tools as they were stored in the jack
storage compartment. Attach the wrench back to
the jack. Put the jack base on the bracket tab
and sit the jack properly between the two "ears" of
the bracket. Use the bolt to tighten the jack.
7. Put the compartment cover back on, slip the tabs
on the bottom of the cover into the bottom of the
cover opening. Push the cover in place and
push down the tab on the top of the cover so that it
rests in the groove. This secures the cover in
place.
Storing the Flat Tire with the Sliding
Rear Convenience Tray
A. D-ring
B. Sliding Rear
Convenience Tray
C. Wing Nut
D. J-hook
1. Push the sliding rear tray forward to the stored
position.
2. Open the driver's side storage compartment door
of the sliding rear tray.
E. Full-size Tire
F. Storage
Compartment
Cap Hole
5-81