Bulb Replacement; Halogen Bulbs; Headlamps - Pontiac Aztek 2003 Owner's Manual

Hide thumbs Also See for Aztek 2003:
Table of Contents

Advertisement

If the level is below the bottom of the filler plug hole,
you'll need to add some lubricant. Add enough lubricant
to raise the level to the bottom of the filler plug hole.
A fluid loss could indicate a problem; check and have it
repaired, if needed.
What to Use
Refer to the Maintenance Schedule to determine what
kind of lubricant to use. See Part D: Recommended
Fluids and Lubricants on page 6-15 .

Bulb Replacement

For the type of bulbs, see Replacement Bulbs on
page 5-49 .
For any bulb changing procedure not listed in this
section, contact your dealer.

Halogen Bulbs

{
CAUTION:
Halogen bulbs have pressurized gas inside and
can burst if you drop or scratch the bulb. You or
others could be injured. Be sure to read and
follow the instructions on the bulb package.

Headlamps

1. Open the hood.
3. Unsnap the headlamp assembly by pulling it
forward, away from the vehicle.
4. Disconnect the electrical connector by pulling back
on the locking tab, located on the electrical
connector, to separate the two connectors.
2. Push in on the
headlamp and lift up
the headlamp retaining
clip partway, but do
not remove.
5-45

Advertisement

Table of Contents
loading

Table of Contents