Table of Contents
Advertisement
Setting Clock Time
1.
Enter the programming mode.
2.
Press button #4 repeatedly until the
3.
Press button #1 to select and enter clock setting mode.
4.
Press button #1 to scroll through 'hour', 'minute' settings. The selected item will be
flashing.
5.
Press button #2 to adjust the setting of the selected item.
6.
Press button #4 to save setting and exit, or press button #3 to abort.
Encoding a Transceiver
Note: Transceivers are programmed from the factory. Encoding is only necessary should the
Transceiver loses its codes and will not arm or disarm the security system or if a second
or replacement remote is obtained.
1.
Unplug HAR-1 from the MCM and plug it back in, the siren will chirp 2 times and the lights
will flash 2 times.
2.
Within 6 seconds turn ignition switch "ON" and "OFF" 3 times.
3.
If step 3 is done correctly and within the time allowed , the siren will chirp 2 times and
the lights will flash an additional 2 times to confirm that the system is in "Learn Mode".
4.
Press and hold button # 1 until the system chirps 2 times and the lights flash 2 times to
indicate that the MCM has learned the code.
5.
The Transceiver echoes 4 chirps and the LCD displays [LErn donE] to confirm that the
Transceiver is encoded.
6.
Turn ignition "ON" and "OFF" to exit "Learn Mode".
Transceiver Battery Information
The receiver is automatically turned on when ever the system is armed. To conserve battery the
transceiver should be turned off when not in use, or when it's out of range for extended periods
of time.
Powering off receiver
Press and hold the #4 button until the transceiver chirps and the LCD only shows the
icons. The receiver is turned off.
Low Battery Stages
It's recommended that the transceiver be charged daily when in regular used. If the transceiver
is not charge daily the following stages will occur.
Low Battery:
Receiver Turns Off: If the transceiver is not charged, at some point (approximately 7 days) the
No response:
When the battery is low the
The transceiver should be charged as soon as possible.
receiver will shut off. At this stage the LCD displays [CHRG BATT PAGE OFF]
and there are no bars in the
If the battery is not recharged and all power is drained. The transceiver will
not respond. The transceiver has to be fully charged before it can operate
the system again. At this stage the LCD displays [CHRG BATT PAGE OFF] and
the no-bar icon
icon begins to flash.
icon will cycle from 3 bars to 2 bars to 1 bar.
icon.
will flash.
11
and
Advertisement
Table of Contents
