Table of Contents
Advertisement
Usage of the Remote Controller
Replacing Batteries
The Remote Controller uses two alkaline dry batteries (R03/Ir03X2).
1.
For the first time of using Slide the back cover of the battery compartment, according the
Direction (+and -)shown on the surface inserí a couple new batters.
2.
To replace the old batteries in the same way as the mentioned aboye.
NOTE
1.
When replacing batteries do not use old batteries or different type batteries. Such using
may cause the remoce controller to malfunction.
2.
lf you do not use the remoce controller for severa/ weeks remove the batteries.
Otherwise battery leakage may damage the remoce controller.
3.
The average battery life in the normal using way is about 6 months.
4.
Replace the batteries when there is no receiving beep from the indoor unit or if the
transmission indicator on the remoce controller fai/s to light.
AUTOMATIC OPERATION
When the Air Conditioner is ready to be operated. Switch on the power and the OPERATION
in dicator lamp on the display panel of the indoor unit starts flashing.
1.
Mode select button MODE select AUTO.
2.
Push the TEMP button to set the desired the temperature normally. The most
comfortable, setting temperature is from 21 °C to 28°C.
3.
Push the ON/OFF button to start the air conditioner. The OPERATION lamp on the
display panel of the indoor unit lights. The operating mode is AUTO FAN SPEED is
automatically set and there is no indicators shown on the display panel of the remoce
controller.
4.
Push the ON/OFF button again to stop the operation of air to conditioner.
NOTE
On the Mode of AUTO the air conditioner can make a logic judgement to choose the
1.
mode of COOL, FAN, HEAT and DRY for cool only type according to difference
between the actual indoor temperature and the setting temperature.
2.
lf the AUTO mode is not comfortable for you then select the desired mode manually.
COOLING HEAT and FAN ONLY Operation
1.
Push the MODE button select COOL, HEAT cooling only type without or FAN ONLY.
2.
Push the TEMP button to set the desired temperature when cooling the better settings is
21 °C or aboye when heating the better settings is 28°C or below.
3.
Push the FAN SPEED to select the FAN mode of AUTO, HIGH, MED or LOW.
4.
Push the ON/OFF button, the operation lamp lights and the air conditioner start to
operate as your settings. Push the ON/OFF button again to stop it.
NOTE
The FAN ONLY mode can not be used to control temperature. Therefore perform only steps
of No.1. 3 and 4 to select Chis mode.
7
Advertisement
Table of Contents
