Inbound Filter - D-Link DWR-921 User Manual

Section 3 - Configuration
Inbound Filter enables you to control what packets are allowed to come in to your network from the Internet. The inbound filter only applies to
packets that are destined for Virtual Servers or DMZ hosts. After modifying any settings, click Save Settings to save your changes.

Inbound Filter:

Use Schedule Rule:
ID:
Source IP : Ports:
Destination IP : Ports:
Enable:
Schedule Rule #:
Previous Page:
Next Page:
D-Link DWR-921 User Manual
Inbound Filter
INBOUND FILTER SETTING
Select this box to Enable the filter.
Select a schedule to use and copy to the specified rule ID
when you click the Copy to button. You may select Always On
or use a specific schedule that you have defined. To create and
edit schedules, please refer to "Schedules" on page 58.
INBOUND FILTER RULES LIST
Here, you can select whether to Allow or Deny all incoming
traffic except for traffic that matches the listed rules.
This identifies the rule.
Specify the local IP address and then specify the port after the
colon.
Specify the remote IP address and then the port after the
colon.
Check the box to enable the specified rule.
Specify the schedule rule number. Click on the Add New Rule
button to create a new schedule rule.
Go back to the previous filter page.
Advance to the next filter page.
43