Table of Contents
Advertisement
$FHU 6OLP
Caution
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes
before replacing the lamp.
To reduce the risk of injuries to fingers and damage to internal components, use
caution when removing lamp glass that has shattered into sharp pieces.
To reduce the risk of injuries to fingers and/or decreasing image quality by touching
the lens, do not touch the empty lamp compartment when the lamp is removed.
This lamp contains mercury. Consult your local hazardous waste regulations to dis-
pose of this lamp in a proper manner.
Resetting Lamp Hours
If you replace the lamp after 1500 hours of operation, please proceed as follows
within 10 minutes of powering on.
OSD
0DLQWHQDQFH
FUNCTION
Press the Exit button on the projector
for 3 seconds to display the total used
lamp time.
Press the MENU button on the
projector during the lamp hour
message. An adjustment message will
appear.
9
:
•
Press
or
to select the setting.
To select the default setting, select
"Reset" (or "Cancel" to return to the
default setting).
•
Press EXIT to leave.
Advertisement
Table of Contents
