Advertisement
TROUBLESHOOTING
Problem
Relocate the display console and/or the wireless
Low or NO
sensor. Both units must be within 330 feet (100
Wireless Sensor
meters) from each other. Make sure both units are
Reception
placed at least 3 feet (.91 m) from other electronic
appliances and devices that may interfere with the
wireless communication (such as TVʼs, microwaves,
computers etc). NOTE: It may take up to 20 minutes
for the display console to re-synchronize with the
low reception
sensor when batteries are replaced. Use lithium
batteries in sensor when temperature is below -4ºF
(-20ºC). Make sure the A-B-C switch selection in
the battery compartments of the display unit and
sensor match.
NO reception
no bars and flashing
" - - " temp/humidity data
As with any weather forecast, 100% accuracy is
not possible. However, this weather station has a
patented "fourteen day learning mode" calibration
process. During this learning mode the weather
station will make altitude calculations that may
Forecast
affect the accuracy of the forecast. Once the 14
day learning mode process is complete, the
Seems
learning mode icon will disappear and the weather
Inaccurate
forecast should be ready for superior operation.
Make sure the wireless outdoor sensor is placed
outdoors and is placed in a location that will most
accurately report the outside temperature and
humidity conditions, these readings directly affect
the forecast feature.
The display may fail to start properly due to static
discharge.
Batteries may need replacing.
Check that batteries are correctly installed.
Display Console
Screen Not Working
Press the reset button located within the battery
compartment of the display unit to reset the entire
unit. Please note that all of the date and time
information will need to be entered manually after
a reset.
www.AcuRite.com
Possible Solution(s)
(877) 221-1252
7
TROUBLESHOOTING
Set Wireless ID
This wireless weather
station uses long range
433mhz radio frequency
for communication.
In the event that you have
reception problems due to
interference, both the
display unit and the
wireless sensor have
a selectable wireless ID.
The ID switches are
located within the battery
compartments of the
display unit and the
wireless sensor.
You may choose A, B or C;
but both the display unit
and the wireless sensor
Reset
ID's must match for
Button
successful synchronization.
IMPORTANT NOTICE
YOUR PRODUCT MUST BE REGISTERED TO RECEIVE WARRANT Y SERVICE
PRODUCT REGISTRATION
To receive product updates
and information, Go to
www.AcuRite.com
Have questions about product setup or operation? We're here to help!
www.acurite.com
24/7 Support:
Product Setup & Demo Videos
Product Manuals
Frequently Asked Questions
A B C
A B C
Both wireless ID's
must match
Register a Product
Register your Product
Support Forum
Submit Feedback & Ideas
8
Advertisement
