Power On/Off - Hitachi CP-AW3019WN Operating Manual

Power on/off

Turning on the power
1.
Make sure that the power cord is firmly
and correctly connected to the projector
and the outlet.
2.
Make sure that the POWER indicator is
steady orange (128).
3.
Confirm that there is nothing that the lens
door hits while opening. Press STANDBY/
ON button on the projector or the
remote control. The lens door opens, the
projection lamp lights up, and the POWER
indicator begins to blink green. When the
power is completely on, the indicator will
stop blinking and light in steady green
(128).
To display the picture, select an input signal according to the section Selecting an
input signal (24).
The INITIAL SETTING Menu will be displayed by factory default upon startup.
Once the INITIAL SETTING Menu is set, it will not appear until FACTORY RESET
(73) is executed. If you wish to change the settings, refer to the LANGUAGE
(55) and ALTITUDE (66) menu.
(1) LANGUAGE: Use the ▲/▼/◄/►
buttons to select the desired language
and press the ENTER button of the
remote control or the INPUT button of
the projector to execute.
(2) ALTITUDE: Use the ▲/▼ buttons to
select NORMAL for altitude below 1600
m (5250 feet), otherwise select HIGH
and press the ENTER button of the
remote control or the INPUT button of
the projector to execute.
(continued on next page)
Power on/off
STANDBY/ON button
POWER indicator
MY SOURCE/
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY PAGE VOLUME
FREEZE UP
ON ＋
AUTO
ASPECT SEARCH BLANK
OFF DOWN
ー
MY BUTTON
KEYSTONE MUTE
1 2
PAGE VOLUME
MAGNIFY FREEZE
FOCUS D-ZOOM
+ - +
-
UP
ON
POSITION MENU
ENTER
DOWN
OFF
ESC RESET
KEYSTONE
MY BUTTON MUTE
1 2
POSITION MENU
ENTER
RESET
ESC
21