Installation; Top Mount; Hanging Mount - Shure SCM268 User Manual

Supplied Hardware
4 rubber feet. For stand-alone installation.
1 rackmount bracket, long. For half-rack (single unit) instal-
lations.
1 rackmount bracket, short. For half-rack (single) or dual-
mount installations.
2 straddle brackets. For dual-mount or fixed installations.
12 bracket screws, 1/4 in. (6 mm). For securing the brackets
to the chassis.
4 rackmount screws, 1 in. (2.5 cm). For mounting the unit in
a rack.
4 plastic washers. For use with the supplied rackmount
screws.
4 wood screws, 1/2 in. (1.25 cm). For fixed installations.
Bracket Screw
Rackmount Screw
Rackmount Installation
The SCM268 can be mounted as a single unit or dual-
mounted with either another SCM268 or another Shure half-rack
unit such as the SCM262 or DFR11EQ.
1. Attach the rackmount brackets using one of the following
methods:
Single unit (half-rack) installation: Attach the short and
long rackmount brackets to the SCM268 with eight (8) of the
supplied bracket screws.
Dual-mounted installation:
a) Connect the two units together side-by-side using two
(2) straddle brackets. The brackets should straddle the
recessed edges on on the top and bottom of each chas-
sis. Fasten them using eight (8) bracket screws.
NOTE: Be sure to use both straddle brackets—one on
the top and one on the bottom.
b) Attach the short rackmount brackets to the outsides of
the combined units with eight (8) of the bracket screws.

INSTALLATION

2. After attaching the brackets, mount the unit in an equipment
rack using the supplied rackmount screws and plastic wash-
ers.
Stand-Alone Installation
Adhere the four (4) supplied rubber feet to the bottom of the
unit at each corner. This will keep it from sliding and protect the
table surface.
Wood Screw
Fixed Installation
To permanently affix the SCM262 above or below a table,
shelf, or counter top, use the following steps:
1. Fasten the straddle brackets to the recessed edges of the
chassis using four (4) bracket screws.
Top mount: Fasten the straddle brackets to on the bottom of
the unit
Hanging mount: Fasten the straddle brackets to the top of
the unit.
2. Fasten the straddle brackets to the surface using the four (4)
supplied wood screws.
English – 4

TOP MOUNT

HANGING MOUNT