Epson EMP-800 User Manual page 83

Projector
Indicator status
status
Lamp operating
red red
error
High
red red
temperature
inside projector
(overheating)
Problem and remedy
This can happen when the power cord was
disconnected from the electrical outlet before
the cool-down period had finished the last
time the projector was turned off.
When turning off the projector, wait 2
minutes. After about 2 minutes, the cooling
fan will stop. When the cooling fan stops,
disconnect the power plug and then re-insert
it. When the power cord is plugged back in,
the projector will return to its previous state,
so press the [Power] button on either the
remote control or the projector's control panel
to turn it back on. If the lamp operating error
happens again or the indicators show a
problem when the power is turned back on,
stop using the projector, disconnect the power
cord from the electrical outlet, and contact
your dealer or the nearest address provided on
page 11 of the Safety Instructions/World-
Wide Warranty Terms.
The lamp will turn off automatically and
projection will stop. Wait for about 5 minutes
without operating the projector. After 5
minutes have elapsed, the projector's cooling
fan will stop. Once the cooling fan has
stopped, unplug the power cord and then plug
it back in again.
If the projector overheats, check the
following two points.
• Is the setting-up location well ventilated?
Check that the air inlet and air outlet are
clear, and that the projector is not
positioned against a wall.
• Is the air filter blocked with dust?
If the air filter is dirty, it should be cleaned.
When the power cord is plugged back in, the
projector will return to its previous state, so
press the [Power] button on either the remote
control or the projector's control panel to turn
it back on. If the projector continues to
overheat even after the above points have
been checked, or if the indicators show a
problem when the power is turned back on,
stop using the projector, disconnect the power
cord from the electrical outlet, and contact
your dealer or the nearest address provided on
page 11 of the Safety Instructions/World-
Wide Warranty Terms.
Reference
page
P.18
P.92
81