Remote Control Command Table; Fault Condition Alerts - Clifford 3806X Owner's Manual

Remote Control Command table

Direct Access
Arm/Lock
(Panic)
Disarm/Unlock
Remote Start*/
Aux 1/4**
Aux/Trunk
AUX
Advance Level,
Change Car
(3 sec), Enter
programming
(8 sec)
* Available only with optional remote start module installation
** This button can command either aux 1 or aux 4 if turned on by
an authorized Directed dealer.
*** Not available for 1-way companion remote control.

Fault Condition Alerts

If, when performing a command, a condition exists that does not al-
low activation of an Alarm feature*, a fault tone plays to alert of the
fault condition.
* Alarm feature not available when the system status is incorrect
upon receiving the command. (Example: Sensor bypass com-
mand is received when disarmed).
Refer to the notes included in the following command descriptions
that address these faults or go to Feature not Available under the
"Remote and System Operations" on page 24 for details.
© 2014 Directed. All rights reserved.
x 1
LEVEL 1
Silent Arm Sensor
Bypass
Silent Disarm Remote Valet
AUX 1 AUX 2
Arm Status
***
x 2
LEVEL 2 LEVEL 3
Sensor Silent
Arm
Car Finder
AUX 3
x 3 x 4
LEVEL 4
Full Silent
Arm
AUX 4
7