Switch The Device On And Off; Antenna Locations; Configuration Settings - Nokia 6730 classic User Manual

Get started
With USB charging, you can also transfer data with the USB
data cable while charging the device.
1. Connect a compatible USB device to your device using a
compatible USB data cable.
Depending on the type of the device that is used for
charging, it may take a while for charging to start.
2. If the device is switched on, select from the available USB
mode options on the display of the device.

Switch the device on and off

Press and hold the power key to
switch the device on and off.
Press the power key briefly to
end a call or close an application.
If the device asks for a PIN code,
enter the PIN code, and select
OK.
If the device asks for the lock
code, enter the lock code, and
select OK. The factory setting for
the lock code is 12345.
To set the correct time zone,
time, and date, select the
country you are presently in,
then enter the local time and date.
12

Antenna locations

Your device may have internal and external antennas. As with
any radio transmitting device, avoid touching the antenna
area unnecessarily while the antenna is transmitting or
receiving. Contact with such an antenna affects the
communication quality and may cause the device to operate
at a higher power level than otherwise needed and may
reduce the battery life.

Configuration settings

Before you can use multimedia messaging, e-mail,
synchronisation, streaming, and the browser, you must have
the proper configuration settings in your device. Your device
may automatically configure browser, multimedia
messaging, access point, and streaming settings based on
the SIM card used. If not, you can use the Settings wizard
application to configure the settings. You may receive the
settings as a configuration message that you can save to your
device. For more information on availability, contact your
service provider or nearest authorised Nokia dealer.
© 2009 Nokia. All rights reserved.