Table of Contents
Advertisement
(5) Configure the settings of the system controller (G(B)-50A or TG-2000A).
Configure settings for the system controller (G(B)-50A or TG-2000A) such as the type of sensor to use and the measurement range.
The main items that should be set are shown below.
(a) When using Pt100 detection (only channel 1 can be used)
Ch
Measurement category setting
Ch1
Measurement range setting
Measurement correction
(b) When using an analog input (4 to 20 mADC detection, 1 to 5 VDC detection, or 0 to 10VDC detection)
Ch
Measurement category setting
Ch1
Measurement range setting
Measurement correction
Measurement category setting
Ch2
Measurement range setting
Measurement correction
(c) When using upper/lower limit alarm interlock output
Ch
Upper/lower limit alarm detection value and
Ch1
cancellation value settings
Upper/lower limit alarm detection value and
Ch2
cancellation value settings
(6) Settings for the interlock function are performed from the maintenance tool.
Perform settings such as interlock criteria for this device from maintenance tool.
For details, refer to the instruction manual for the maintenance tool.
Setting
Setting
Setting
9
Setting with G(B)-50A or TG-2000A
Select temperature/humidity (Be sure to select
temperature.)
Set the upper limit and lower limit values
(Set a range from -30°C [-22°F] to 60°C [140°F].)
Input the measurement temperature correction value
(offset value)
Setting with G(B)-50A or TG-2000A
Select the temperature/humidity
Set the upper limit and lower limit values
Input the measurement correction value (offset value)
Select the temperature/humidity
Set the upper limit and lower limit values
Input the measurement correction value (offset value)
Setting with G(B)-50A or TG-2000A
Upper/lower limit alarm detection value and cancellation
value settings
Upper/lower limit alarm detection value and cancellation
value settings
Advertisement
Table of Contents
