Table of Contents
Advertisement
ADJUSTING THE FENCE 90° TO THE BLADE
DISCONNECT MACHINE FROM POWER SOURCE!
If the fence (A) Fig. 24 is removed from the saw, adjust it after replacement so that it is 90° to the blade.
1.
Place one end of the square (B) Fig. 24 against the fence (A) and the other end against the blade.
2.
To adjust, loosen the four screws (C) Fig. 25, and adjust fence 90° degrees to the blade. Tighten the four screws (C).
A
ADJUSTING THE DOWNWARD TRAVEL OF THE SAW BLADE
DISCONNECT MACHINE FROM POWER SOURCE!
1.
You can limit the downward travel of the saw blade to
prevent it from contacting any metal surfaces of the
machine. Make this adjustment by loosening the locknut
(A) Fig. 26 and turning the adjusting screw (B) in or out.
2.
Lower the blade as far as possible. Rotate the blade by
hand to make certain the teeth do not contact any metal
surfaces.
3.
Tighten the locknut (A)
ADJUSTING 90° AND 45° BEVEL STOPS
DISCONNECT MACHINE FROM POWER SOURCE!
1.
Loosen the bevel lock handle (A) Fig. 20 and move the cutting arm (B) Fig. 20 all the way to the right. Tighten the bevel lock
handle.
2.
Place one end of a square (A) Fig. 27 on the table and the other end against the blade. Check to see if the blade is 90° to the
table (Fig. 27).
3.
To adjust, loosen the locknut (B) Fig. 28, and turn the screw (C) until the head of the screw (C) contacts the casting (D) when
blade is 90° degrees to the table. Tighten the locknut (B).
Fig. 27
B
C
Fig. 24
A
Fig. 28
14
B
C
Fig. 25
A
Fig. 26
D
B
Hide quick links:
Advertisement
Table of Contents
