GE 18 Owner's Manual page 31

Reversing the hardware.
Transfer Bottom Hinge Bracket to the Left
1
Remove the base grille by pulling it straight out.
2 Using a Torxdriver, move the bottom hinge bracket and plastic washer from
the right side to the left side.
Transfer Center Hinge Bracket to the Left
Do not remove
this screw
Center Right
1 Remove the center hinge
bracket by removing the three
Torx screws.
NOTE: Keep these screws with the hinge
bracket. They are long screws and will be used
when installing the hinge on the other side.
Transfer Top Hinge to the Left
Interchange hinge and screws at top right with screws at top left of cabinet.
Do not tighten screws on hinge side at this time.
Transfer Door Stops
1 On each door, move the metal door stop from the right to the left.
2
Move any screws from the left to the right.
Plastic Washer
Hinge Bracket
2 Remove the three Torx screws
from the center left side of the
cabinet. Screw them into the holes
on the right side.
Place the center hinge bracket
over the holes at the center left
side of the cabinet. Insert and
tighten the three long screws.
Do not remove
this screw
Center Left
31