Remak DoorMaster C1 Installation And Operating Instructions Manual page 4

Designation, Storage and Dispatch
The covering sidewalls are laminated. The intake panel
has an integrated filter insert (G1). The exhaust cham-
ber is furnished with anti-noise insulation. The exhaust
screen is adjustable. As standard D2 curtains are equi-
pped with 3-speed fans made by leading european ma-
nufacturer. The D2 curtains are equipped with fan units
from the leading manufacturer of fans, Nicotra, and in
the standard version, they have a three-step speed con-
trol. In the standard version, the three-row Cu/Al water
exchanger (version W) in lengths up to 2.0 m comes
with one connection for the media and with two conne-
ctions in a length of 2.5 m. The electric exchanger is
delivered with stainless coiled heating rods (two outputs
- version E1 and E2). The over-all electric protection of
the covered curtain is IP 20.
Side Arrangement of Air Curtains
All media are connected from above. Electric wiring is
led through the grommets; the hot water is connected to
the header necks (3/4" outer thread). The C and D air
curtains' electric connection is always situated on the
right side (looking at the air curtain from the inlet side);
the water heater connection is situated on the right side
with the C air curtains, respectively on the left side with
the D2 air curtains, see figures #6 and #7.
Designation of the air curtain
Each curtain is furnished with a type (manufacturing)
plate located on the left (C curtain) or on the right (D
curtain) on the upper panel of the curtain (at the spot
for the feed-in of electricity), on which the following is
listed:
name of the manufacturer (including the logo)

and the address
designation of conformity CE, ROST

type designation

manufacturing code

date of manufacture

manufacturing number

max. airflow

over-all electric input power

electric protection

power-supply voltage

max. nominal current

weight

and further when it is a manufacturing component:
water heater
heating output

maximum permissible temperature of water

maximum permissible pressure of water

electric heater
heating output

Information and safety plates
Plates with the warning sign "Attention electric

device!" on the safety covers of the wiring
Inlet and outlet for heating water (version W)

Plate with the warning "Attention! When connecting,

see to it that the connecting cables do not extend
into the fan's intake!" (D2 curtain)
4
Figure 1 - designation of curtains
C1 - E1 - 150 / TR-M
optional equipment
curtain to which it is possible to connect
further chained curtains **)
three-step speed control
(applies only to C1)
basic equipment
length of curtain
(100, 150, 200, 250 cm)
type of heating:
N - low-temperature
E1 - electric heating lower
E2 - electric heating higher
W - water heating
type of curtain
(C1, D2)
*) Code SP with D2 air curtains: compliant with ErP 2013
**) more in the chapter "Chaining of curtains"
Make sure that all designations on the device are legi-
ble and undamaged for the whole time of usage.
Storage
The curtains can be stored only horizontally on wooden
palettes (part of the packaging).
Turning over and storing in another position is prohi-
bited! For purposes of transporting and storing, three
curtains at most can be stacked up if they are secured
against sliding. The allowable storage conditions for a
device packaged in the standard manner according to
ČSN EN 60721-3-1: IE11 (+5°C +40°C, max. 85% rela-
tive humidity without condensation and frost formation).
Packaging
The bodies of the DoorMaster air curtains are packaged
in cardboard boxes on wooden palettes. The product is
fixated in the box by means of polystyrene fillers. The
D2-250 curtains are shipped on a palette.
Transport and handling of the parts
For handling, lifting and hanging the curtain, use only
suitable means with sufficient load capacity. Transport
Figure 2 - manufacturing plate
When disposing of the wrapping, be sure to observe the
appropriate government regulations regarding the envi-
ronment and waste disposal.
Air curtains
the curtain only on a
palette that is secured
against jolts, impacts
and overturning. For
your own safety, wear
gloves when handling
the device. Do not
move the load over
people's heads. When
hanging the curtain,
be careful not to da-
mage the parts of its
casing.
Remove the protecti-
ve wrapping shortly
before mounting.