Remak DoorMaster C1 Installation And Operating Instructions Manual page 10

Installation, Media Connection
Raise the curtain and slide the hanging profile

between the binding washers.
Tighten the nuts (counter).

Carry out the connection of the media (see page 11).

Carry out the connection of the control and main

lead-in for the electric power (see page 12).
Hanging on the wall with the help of wall hangers
(the accessory is ordered separately, only C1 curtains)
The hanging consoles make two kinds of fastening
possible: above the curtain and on the level of the cu-
rtain. The choice of hanging depends on the particular
installation.
Dismounting procedure
Affix the wall hangings. Determine the correct positi

on of the hangings according to illustration No. 11
on page 11.
Dismount the original hanging profiles from

the product.
Screw in the M8x40 hanging screw with the 8 spring

washer and the 8.4 washer halfway into the front
nuts on the upper side of the curtain; leave the rear
nuts empty.
Figure 10 - mounting on the threaded bars (C1)
Figure 11 - mounting on the hanging console (C1)
Figure 12 - mounting on the threaded bars (D2)
10
Set the curtain (behind the heads of the screws)

into the hanger.
Screw the M8x40 safety screws with the 8 spring

washer and the 8.4 washer into the rear nuts.
Tighten all screws.

Carry out the connection of the media.

Carry out the connection of the control and main

lead-in for the electric power (page 12).
Dismounting of the C1 service panels
Dismounting procedure
Loosen the fast closures located in the openings

in the intake panel. Do the loosening with
a screwdriver by turning the fast closure 90 degrees
to the right - The screw must spring out.
Open the intake panel and take it off.

Unscrew the right lateral protective cover for the

wiring (Phillip's head screwdriver): 2x self-cutting
screw, 1x M5x10 screw.
Remounting is carried out using the reverse procedure.
Dismounting of the D2 service panels
Dismounting procedure
Loosen the fast closures located under the intake

panel. Do the loosening with a screwdriver by
turning the fast closure 90 degrees to the right -
The screw must spring out.
Open the intake panel and take it off.

Loosen and open the lower service panel

(M6 screws on the lower edge).
Remounting is carried out using the reverse procedure.
Heating Water Piping
Installation, commissioning and maintenance of the
device can only be performed by professionally trained
persons who have been informed on possible dangers
arising from the assignments which they have been
authorized to carry out.
The air curtains with water heat exchangers (W) are
equipped with G 3/4" external thread. Do not use ex-
cessive force when connecting the building's hot water
circuit to the air curtain. When screwing and tightening,
the screw connections of the heat exchanger must be
secured against turning by clamping tools, otherwise
the heat exchanger piping could be damaged.
Figure 13 - connection of heating water (flexible pipe)
Air curtains