Attaching The Air Purifying Filters - Hitachi RAS-08LH2 Instruction Manual

ATTACHING THE AIR PURIFYING FILTERS

CAUTION
Cleaning and maintenance must be carried out only by qualiÀ ed service personal. Before cleaning,
stop operation and switch off the power supply.
1
Open the front panel.
● Pull up the front panel by holding it at both sides with
both hands.
2
Remove the pre-À lters.
● Push upward to release the claws and pull out the
pre-À lters.
3
Attaching the air purifying À lters to the pre-À lter.
● Attach the air purifying À lters to the frame by gently
compress its both sides and release after insertion
into À lter frame.
Do not bend the air purifying À lter as
it may cause damage to the structure.
Please do not smell direct from source
of À lter.
4
Attach the pre-À lters.
● Attach the pre-À lters by ensuring that the surface
written "FRONT" is facing front.
● After attaching the pre-À lters, push the front panel at
three arrow portion as shown in À gure and close it.
NOTE
●
In case of removing the air purifying À lters, please follow the above procedures.
●
The cooling capacity is slightly weakened and the cooling speed becomes slower when the air purifying À lters are
used. So, set the fan speed to "HIGH" when using it in this condition.
●
Air purifying À lters are not washable. It is recommended to use vacuum cleaner to clean it. It can be use for 1 year
time. Type number for this air purifying À lter is <SPX-CFH22>. Please use this number for ordering when you want
to renew it.
●
Do not operate the air conditioner without pre-À lter. Dust may enter the air conditioner and fault may occur.
CAUTION
Claws Claws
(4 places) (4 places)
– 20 –