Attaching The Air Purifying Filters - Hitachi RAS-10G5 Instruction Manual

ATTACHING THE AIR PURIFYING FILTERS

CAUTION
Cleaning and maintenance must be carried out when fi lter lamp lights. Before cleaning, stop
operation and switch off the power supply.
Open the front panel
● Pull up the front panel by holding it at both sides
with both hands.
Remove the pre-fi lter
● Push upward to release the claws and pull out the
fi lter.
Attaching the air purifying fi lters
● Attach the air purifying fi lters to the frame by gently
compress its both sides and release after insertion
into pre-fi lter frame.
CAUTION
Do not bend the air purifying
fi lter as it may cause damage
to the structure.
Attach the pre-fi lters
● Attach the pre-fi lters by ensuring that the surface
written "FRONT" is facing front.
● After attaching the pre-fi lters, push the front panel
at three arrow portions as shown in fi gure and close
it.
NOTE
● In case of removing the air purifying fi lters, please follow the above procedures.
● The cooling capacity is slightly weakened and the cooling speed becomes slower when the air
purifying fi lters are used. So, set the fan speed to "HIGH" when using it in this condition.
● Air purifying fi lters are washable and can be use in 1 year time. Type number for this air purifying
fi lter is <SPX-CFH11>. Please use this number for ordering when you want to renew it.
●
Do not operate the air conditioner without pre-fi lter. Dust may enter the air conditioner and fault
may occur.
Claws
(4 places)
– 15 –