Table of Contents
Related Manuals for Euro Kitchen Appliances PS29
Summary of Contents for Euro Kitchen Appliances PS29
- Page 1 Installation Guide and Users Manual Professional Series (PS29) IMPORTANT: Read and save these instructions. NOTICE: Installer: Leave this guide with the homeowner Homeowner: Keep this guide for future reference Wall Mount Range Hood...
-
Page 3: Important Safety Notice
Important Safety Notice Read all Instructions before Installing and operating this appliance • The installation in this manual is intended for qualified installers, service technicians or persons with Installation Guide similar qualified background. Installation and electrical wiring must be done by qualified profession- als and in accordance with all applicable codes and standards, including fire-rated construction. - Page 4 Important Safety Notice Read all Instructions before Installing and operating this appliance • Clean ventilating fan frequently. • Always use appropriate cookware and utensils size. • Always use cookware appropriate for the size of the surface element. To reduce the risk of injury to persons in the event of a stove top grease fire: •...
-
Page 5: Parts Supplied
Parts supplied: plied: Upper Chimney Lower Chimney Range Hood Chimney-mounting Bracket Hood-mounting Bracket Qty: 4 PCS Qty: 2 PCS (30-in models) Qty: 3 PCS (36-in models) Qty: 6 PCS Qty: 4 PCS (30-in models) Qty: 6 PCS (36-in models) Qty: 2 PCS (30-in models) Qty: 3 PCS (36-in models) Qty: 4 PCS Qty: 4 PCS... -
Page 6: Venting Requirements
Venting Requirements Height & Clearance Chimney- • Vent system must terminate to the outside (roof or side wall). Maximum ceiling clearance mounting 110” at 30” hood mounting • DO NOT terminate the vent system in an at- Bracket height above countertop/ tic or other enclosed area. -
Page 7: Calculating Vent System Length
IMPORTANT: • A minimum of 6” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separate- ly) must be used to maintain maximum airflow efficiency. • Always use rigid type metal/aluminum ducts if available to maximize airflow when connecting to provided duct. -
Page 8: Venting Methods
Venting Methods • This range hood is factory set for venting through the roof or wall. • Vent work can terminate either through the roof or wall. To vent through a wall, a 90° elbow is needed. IMPORTANT: • NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. -
Page 9: Electrical Requirements
Electrical Requirements IMPORTANT: Observe all governing codes and ordinances. It is the customer’s responsibility: • To contact a qualified electrical installer. If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate. - Page 10 Preparation Advanced Preparations: • Be familiar with the controls of the range hood by reading through Range Hood Operations, Page 12. • Place the range hood on a flat, stable surface. Connect the range hood to a designated standard outlet (120-Volt, 60Hz, AC only) and turn on the range hood.
-
Page 11: Installation
Installation Installations (refer to Page 4 for parts): Measure the distance between stove top and the bottom of range hood. A distance of 27” to 30” is recommended*. *Due to different ceiling height configurations, recom- mended height may not be applicable. Using references in Height &... - Page 12 Installation (Continued) Connect the range hood to a designated standard outlet (120-Volt, Figure 8 Figure 8 60Hz, AC only) or cut off the plug and connect three wires (black, white and green) to house wires and cap with wire connectors. Con- nect according to colors (i.e.
-
Page 13: Range Hood Operations
Range Hood Operations Control Panel Layout and Buttons Configurations: LED Light LED Speed Indicator Indicators Light Control Speed Control Power Control (On/Off) This range hood is equipped with six electronic controls, oversized powerful centrifugal squirrel cage motor with stainless steel grease tunnel, stainless steel baffle filters and spacers, two bright 12V 20W halogen lights and 120V 250W heating lamp sockets (heating lamps sold separately). - Page 14 Range Hood Operations (Continued) Control Panel Layout and Buttons Configurations: Quiet Medium High Speed Speed Speed Speed LED Light LED Speed Indicator Indicators Light Control Power Control (On/Off) • During this 3-minutes delay, changing speeds will not affect the countdown. Immediate Power-off •...
-
Page 15: Troubleshooting
Troubleshooting If the range hood or halogen light does not operate • Check if the range hood has been plugged in, make after installation: sure that all power has been turned back ON, fused not blown and all electrical wiring are properly con- nected. -
Page 16: Specifications
Use and Care Information Operations: • Read and understand all instructions and warnings in this manual before operating the appliance. Save these instructions for future reference. • Always leave safety grills and filters in place. Without these components, operating blowers could catch on to hair, fingers and loose clothing. - Page 17 Measurements and Diagrams Installation Overview: ation Overview: Chimney- Qty: 4 PCS mounting bracket Qty: 6 PCS Upper support frame Qty: 4 PCS Upper chimney Back of the range hood Qty: 4 PCS (For sheet rock only) Hood-mounting bracket Round duct (exhaust) Range hood Page 16...
- Page 18 • All measurements in parenthesis are in millimeter. • All inch measurements are converted from millimeters, thus inch measurements are estimated. Overall: Page 17...
- Page 19 • All measurements in parenthesis are in millimeter. • All inch measurements are converted from millimeters, thus inch measurements are estimated. Overall without Chiminey: Page 18...
- Page 20 Hood-mounting Bracket: Circuit Diagram: Page 19...
- Page 21 Range Hood Assembly: Description Description Chimney-Mounting Bracket Control Panel Assembly Upper Standard Chimney Processor Board Lower Standard Chimney Baffle Handle Chimney-Mounting Bracket Electrical Box Cover Hood-Mounting Bracket Electrical Box Base Power Cable Halogen Light Transformer Safety Screen Electrical Panel Locknut Control Panel Assembly Panel Squirrel Cage Hood Casing...
- Page 22 Blower Assembly: Description Description Motor Locknut Air Chamber Safety Screen Squirrel Cage Electrical Assembly: Description Description Screws (3/16” x 3/8”) Electrical Panel Electrical Box Cover Capacitor Processor Board Screws (3/16” x 3/8”) Screws (3/16” x 3/8”) Halogen Light Transformer Electrical Box Base Page 21...
-
Page 23: Maintenance
Maintenance SAFETY WARNING: Never put your hand into area housing the fan while the fan is operating! SAFETY WARNING N For optimal operation, clean range hood and all baffle/spacer/filter/grease tunnel/oil container regularly. Regular care will help preserve the appearance of the range hood. Cleaning Exterior surfaces: •... -
Page 24: Warranty
Warranty must rese sent chas date Pl Plea ease a an h a hase l e les re rece i n invo i in d e der ai ain se serv i c ice d e der warr rran One Year Parts Warranty: For one year from the date of original purchase, we will provide free of charge, non- consumable replacement consumable replacement parts or components that failed due to manufacturing defects. - Page 25 Disclaimer Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and signature of the carrier’s agent and keep copy to support your claim. Upon acceptance of items, owner assumes responsibility for its safe arrival. Report damages to the carrier and file a claim immediately.
- Page 26 Euro Kitchen Appliances, Inc. 11312 78Ave. Delta BC http://www.KitchenHoods.ca...