Related Manuals for Euro Kitchen Appliances B02 Series
Summary of Contents for Euro Kitchen Appliances B02 Series
- Page 1 B02 Series Under cabinet Range Hood INSTRUCTION MANUAL www.KitchenHoods.ca READ AND SAVE THE INSTRUCTIONS For domestic cooking only Dear Customer,...
- Page 2 Thank you for purchasing a range hood from www.kitchenhoods.ca! If you follow the recommendations contained in this Instruction Manual, our appliance will give you constant high performance and will remain efficient for many years to come. CONTENTS RECOMMENDATIONS AND SUGGESTIONS CHARACTERISTICS INSTALLATION &...
- Page 3 WARNING TO RUDUCE THE RICK OF FIRE, ELECTRIC SHOCK OR INJURE TO PERSONS, PLEASE OBSERVE THE FOLLOWINGS: Installation work and electric wiring(including switch location) must be １ ． done by the qualified person(s) in accordance with local applicable codes and standards, including fire-rated construction. This hood may have sharp edges.
- Page 4 DO NOT USE WATER, including wet dishcloths or towels- a violent steam explosive will result. Use an extinguisher ONLY if: You know you have a Class ABC extinguisher, and you already know how to operate it; The fire is small and contained in the area where it started; The fire department is being called;...
-
Page 5: Part Lists
NOTE: on the stainless hoods, carefully remove the plastic protective film from exterior of the surfaces of the hood prior to final installation. Caution: To Reduce Risk of Fire And Electric Shock, Install This range hood only with integral Blowers manufactured for Euro Kitchen Appliances Inc. Canada... -
Page 6: Ducting Version
DESCRITION/CONNECTION This appliance may install in ducting version or filtering version. DUCTING VERSION D etermine whether the hood discharge vertically(252 8 0mm or round １ ． × duct)or horizontally(252 8 0mm duct).For vertically or horizontally, run × ductwork between the hood location and the roof cap or wall cap. For best results, use a minimum number of transitions and elbows. -
Page 7: Installation
it through the grease filters and expels it to the outside through an outlet pipe. With this version the charcoal filters are not required. No need of plastic or metal duct. ２ ． Must be install charcoal filter on the hood. ３... - Page 8 Remove the Recirculation Plate out of the hood and use sealing plate to seal the outlet off. Ducted installation only ５ ５ ５ ５ ． ． ． ． Tighten the Recirculation Plate and the outlet with screw. DUCTED INSTALLATION ONLY ６...
- Page 9 Damper/Duct connector to connect to the Knockout openings on the hood. Hold the hood in position under the cabinet. For ducted installation, ７ ． make sure the damper/duct connector enters ductwork and that the damper opens and closes freely. Tighten all 4 mounting screws completely to secure the hood to the ８...
- Page 10 Bottom Cover to the hood. I nstall the Halogen lamp. １ １ ． R eplace the filters and turn on the power at service panel and test for １ ２ ． proper operation. Operation The hood is operated using a rocker switch on the front panel. Blower switch The 3-position blower switch turns the blower ON/OFF and controls the...
- Page 11 blower speed. Set the left side of the switch (0) turns blower on and off. Set the middle of the switch (1) turns blower on to low speed. Set the right side of the switch (2) turns blower on/off. Light switch The 3-position blower switch turns the lights ON/OFF and controls their intensity.
- Page 12 Rinse with water after exposure and wipe dry with a clean cloth. * Painted surfaces should be cleaned with warm water and mild detergent only. Manufactured for: Euro Kitchen Appliances Inc. Burnaby, BC Canada www.KitchenHoods.ca tel.1-800-315-0359...