Starting The Machine - CMA Dishmachines Espresso Coffee Machine Use And Maintenance Manual

R ARATION O T
The preparation of the coffee machine and its installation must be performed by ualified staff.
WARNING
Use of the machine without all the installation operations having been carried out by technical personnel could damage it se-
riously.
TARTING T
CTRICA ATING
Before starting the machine, make sure that the level of water in the boiler is higher than
the minimum level on the level-check window
or after boiler maintenance), it is necessary to fill the boiler in advance, so as to prevent
overheating of the heating element. Proceed as follows
pen the water tap of the water mains and of the softener.
sing manual fill fill the boiler with water until the optimal level is restored.
Turn the switch to position
C
pen the water tap of the water mains and of the softener.
Turn the switch to position
filling and machine services) and wait for the boiler to be automatically filled with water.
Turn the switch to position
in the boiler) and wait for the machine to warm up completely.
WARNING
• during the machine s warm-up phase (roughly
valve itself closes
• before using the machine, run deliveries dry with the filter holder attached for a few seconds to release any air which may be in the
circuit, so that the delivery groups are completely heated
• before using the machine, dispense a few servings of coffee to test the grinding and to check the operating pressure of the machine
AC IN
AC IN
. If there is no water (first installation
and wait for the machine to warm up completely.
(electrical power supplied to the pump for automatic boiler
(full electrical power supplied, including the heating element
minutes), the negative pressure valve will release steam for a few seconds until the
espresso coffee machine - instructions for the user
0
1
0
1
C
english -