Do you have a question about the MARISA and is the answer not in the manual?
Questions and answers
Monika Iwosa
February 18, 2025
Hi I have Marisa coffee maker but was not used for half year. Have you got any videos how to clean and set up everything to be sure machine is used correctly please.
1 comments:
Mr. Anderson
February 18, 2025
To clean and set up the CMA Dishmachines Marisa coffee maker after not using it for six months, follow these steps:
1. Cleaning Before Use: - Empty any old water from the machine and water circuit. - Rinse the entire water system by allowing fresh water to flow through it. - Run at least 0.5 liters of water through each coffee group. - Flush the hot water circuit by dispensing hot water continuously. - Steam should be released continuously for at least one minute to clean the steam wand.
2. Setting Up the Machine: - Refill the machine with fresh water. - Turn on the machine and allow it to reach operating temperature. - Ensure all buttons and functions are working properly. - Clean the steam wand and other external parts with a damp cloth. - Perform a test run by making a coffee to ensure proper operation.
By following these steps, the machine will be clean and ready for use after a long period of inactivity.
Page 1
R E N E WE D & R E L O VE D CMA MARISA Love Coffee Machines Ltd Unit 3 Pear Tree Industrial Estate Bath Road Upper Langford BS40 5DJ sales@lovecoffeemachines.co.uk...
Cup heater ..................68 Accessories ..................69 Softener ....................70 Checks and Maintenance ............. 71 Suggestions on how to obtain a good cup of coffe ... 71 Cleaninge ................... 72 List of hazards ................... 74 MARISA instruction manual for user - ENGLISH...
Read carefully all parts of this manual before using the product. The espresso coffee machine that you have purchased has been designed and manufactured with innovative methods and technology which ensure long lasting quality and reliability. This manual will guide you in discovering the advantages of selecting this product. You will find information on how to get the best out of your machine, how to always keep it efficient and what to do if you should have any problems.
Page 4
When using the electrical appliance, several safety standards must be observed: - do not touch the appliance when hands or feet are wet or damp; - do not use the appliance in bare feet; - do not use extensions in rooms where there are showers or baths; - do not pull on the power cord to disconnect the appliance from the power outlet;...
Presentation This product has been manufactured in compliance with the regulations for foodstuff machinery according to par. 2.1 of Directive 2006/42/EC. The espresso coffee machine is strictly for professional use only. It is designed for the preparation of hot drinks such as tea, cappuccinos and long, short and espresso coffee, etc.
Warnings for the installer Power The water supply of the appliance must be carried out with water which is suitable for human consumption, in compliance with the regulations in force int the place of installation. The owner / manager of the system must confirm to the installer that the water meets the above listed requirements.
Preparation of the machine The preparation of the machine and the installation operations must be carried out by qualified personnel only. The installer must strictly follow the indications provided in chap.."Warnings for the Installer". Use of the machine without all the installation operations having been carried out by technical person- nel could damage it seriously.
10. Grinding and dosing coffee Place the grinder-doser in a convenient place near the machine. Grinding and dosing of coffee must take place in accordance with the instructions of the manufacturer of the grinder-doser. To achieve good quality espresso coffee we suggest the following: • do not keep large amounts of coffee in whole beans.
11. Making coffee SMSA 11.1 version • put the coffee cup under the dispensing spout; • Press the desired delivery switch. You will have the delivery which can be stopped by means of the same switch once the desired amount of coffee in the cup is obtained.
12. Preparation of hot drinks 12.1 Hot water delivery DISPENSING HOT WATER • Put the cup under the hot water spout (3); • press the hot water key : wait for the delivery of water; • to stop delivery in advance, press the hot water delivery key again or press the key PROGRAMMING DOSE OF HOT WATER •...
13. Autosteamer (optional) The autosteamer system dispenses steam and can be used for two purposes: heating a beverage to the programmed temperature foaming + heating milk to the programmed temperature Proceed as follows : 1) Immerge the ends of the autosteamer into the beverage; 2) Press the key 3) Wait until the dispensing is finished;...
14. Cup heater To activate. de-activate of adjust the cup heater, proceed as follows: to OFF ; • Turn the programming key to ON; • Turn the cup-heater switch (13) • Upon start-up of the machine, hold down the key the right push button panel: on the push button panel, the flashing LED will indicate the current configuration of the cup heater as shown in the drawing below;...
15. Accessories Cappuccino maker • Put the suction tube inside the milk; • place the jug under the spout of the cappuccino maker; • turn the steam tap counter-clockwise, upon reaching the desired amount, close the steam tap; • pour the foamed milk into the cups with coffee.
16. Softener Mains water contains insoluble salts, which cause the build-up of lime scale deposits in the boiler and in other parts of the machine. The softener makes it possible to eliminate or substantially reduce the presence of these mineral salts. The resin softener has the property of retaining the calcium contained in the water.
17. Checks and Maintenance Maintenance must be carried out in order to ensure perfect safety and efficiency of the machine over time. In particular, it is advisable to ask the Technical Service to carry out an overall check of the machine at least once a year. Intervention Weekly Monthly GAUGE...
19. Cleaning For perfect cleaning and effi ciency of the appliance, several simple cleaning operations are necessary on the functional parts and accessories as well as the body panels. The indications given here are applicable for normal use of the coff ee machine. If the machine is used continuously, then cleaning should be performed more frequently. Before cleaning the machine, turn it off the machine and let it cool off .
Page 18
When cleaning, always use cloths that are completely clean and hygienic. To guarantee the correct operation and hygiene of the hot beverages dispenser, it is neces- sary to use the cleaning methods and products suitable for this purpose. Do not immerge the machine into water. Never use alkaline detergents, solvents, alcohol or aggressive substances.
20. List of hazards This chapter describes possible hazards for the user if the specific safety standards (described in this manual) are not adhered to. The appliance must be connected to an efficient grounding system If this is not done, the appliance can be a source of dangerous electrical discharges as it is no longer able to discharge electricity to earth.
Need help?
Do you have a question about the MARISA and is the answer not in the manual?
Questions and answers
Hi I have Marisa coffee maker but was not used for half year. Have you got any videos how to clean and set up everything to be sure machine is used correctly please.
To clean and set up the CMA Dishmachines Marisa coffee maker after not using it for six months, follow these steps:
1. Cleaning Before Use:
- Empty any old water from the machine and water circuit.
- Rinse the entire water system by allowing fresh water to flow through it.
- Run at least 0.5 liters of water through each coffee group.
- Flush the hot water circuit by dispensing hot water continuously.
- Steam should be released continuously for at least one minute to clean the steam wand.
2. Setting Up the Machine:
- Refill the machine with fresh water.
- Turn on the machine and allow it to reach operating temperature.
- Ensure all buttons and functions are working properly.
- Clean the steam wand and other external parts with a damp cloth.
- Perform a test run by making a coffee to ensure proper operation.
By following these steps, the machine will be clean and ready for use after a long period of inactivity.
This answer is automatically generated