CMA Dishmachines Espresso Coffee Machine Use And Maintenance Manual page 12

espresso coffee machine - instructions for the user
A A AT
D
• put the coffee cup under the dispensing spout;
• press the desired dose key wait for dispensing to finish ( D comes on);
• to stop coffee delivery in advance, press the delivery key again or press the ST P key;
• to obtain continuous delivery of coffee select the
• if the push button panel malfunctions or is locked, use the manual switch located near the push button panel.
NOT
The timer measures the time and not the amount of coffee in the cup. The same programming may provide different amounts
of coffee depending on how the coffee is ground.
) Press and hold down the ST P PR
correct entry into the programming phase.
) Press on of the two dose keys
programmed stay on.
) hen the desired amount of coffee in the cup has been reached, press the ST P PR
to stop delivery and memorize the new value (the duration of the dose of coffee is calculated in seconds). At the same time, the
the dose which is still to be programmed comes back on, while the
) Proceed with the programming of the other coffee dose by pressing the other dose key. nce the desired amount of coffee in the cup
has been reached, press the dose key or the ST P PR
) To exit programming, press and hold down the ST P PR
In some previous versions of A AP-S AT machines, push button panels are
installed with time adjustment by means of a trimmer
to turn clockwise increases delivery time, turning counter-clockwise reduces
delivery time.
NOT
It is possible to re-program the coffee dose that you have just fi nished programming (LED off) without necessarily having
to turn the system off and back on or exiting the programming phase.
The programming of every dose must be done with ground coffee and not with previously used grounds.
The system automatically exits programming status approximately 10 seconds after the last operation.
- english
R ION
T key. To interrupt delivery press
key for seconds and check that all of the D on the push button panel come on. This confirms
to program. The
PROG.
O T.
STOP
using a screwdriver
D corresponding to the T key (continue) and to the key of the dose being
D for the programmed dose stays off.
again .
key for more than seconds.
O T.
STOP
T again or the ST P key;
key or the key of the dose being programmed
CONT
STOP
PROG
D for