Operation; Filling The Pump With Oil - Greenlee 755 Operation, Service And Parts Instruction Manual

Operation

1. Remove the dust cap.
2. Connect the hose to the bender or punch unit.
Note: Hand-tighten the couplers completely.
Do not use tools.
3. Twist the release knob (7) clockwise until it stops.
4. Pump the handle (9) until the bend or punch is
complete.
5. Twist the release knob (7) counterclockwise to
release the hydraulic pressure.
6. Disconnect the hose from the bender or punch unit.
Replace all dust caps.
Greenlee Textron Inc. / Subsidiary of Textron Inc.
755 Hydraulic Hand Pump

Filling the Pump with Oil

1. Clamp the pump into a vise with the end cap (1)
upward. Loosen the set screw (26) and remove the
end cap.
2. Remove the cap screw (31) with O-ring (18) from
the reservoir follower (3). Remove the follower from
the reservoir. Inspect both V-packings (28); replace
them if they are worn or damaged.
3. Pour Greenlee hydraulic oil* into the reservoir until it
is within 1-3/4" from the top.
4. Reinstall the reservoir follower.
5. Turn the release knob (7) counterclockwise so the
valve is open. Pump the handle (9) two or three
times.
6. Turn the release knob (7) clockwise so the valve is
closed. Pump the handle (9) two or three times.
7. Slowly turn the release knob (7) to counterclock-
wise. This will allow any air trapped in the pump
block (10) or reservoir (8) to escape.
Note: Do this slowly to prevent the oil from suddenly
gushing up through the cap screw hole.
8. Repeat steps 5 through 7 one or two more times.
9. Inspect the O-ring (18) in the cap screw (31);
replace O-ring if it is worn or damaged.
10. Replace the cap screw (31) with O-ring (18) in the
follower (3). Hand-tighten the cap screw.
11. Wipe any excess oil from the outside of the reser-
voir and replace the end cap (1). Tighten the set
screw (26).
* Order Greenlee hydraulic oil by the gallon
(part number 905 1059.3) or by the quart
(part number 905 0806.8).
4 4455 Boeing Dr., Rockford, IL 61109-2988 815/397-7070