iRobot Scooba 5800 Owner's Manual page 22

I'm stuck light
When Scooba is stuck, the robot will tell you the cause of the problem by
saying "uh-oh" and a number of beeps. Count the beeps after the "uh-oh" and
refer to the table below to determine why Scooba is stuck. Usually, when the
I'm Stuck light comes on, you need to re-start Scooba in another location.
warning Possible Cause
light
I'm Stuck One of Scooba's
Light wheels is off the floor
(1 beep)
The front wheel is
stuck (2 beeps)
Bumper problem
(3 beeps)
Scooba's cliff
sensors are dirty or
malfunctioning
(4 beeps)
Left or right wheel
malfunction (5 beeps)
service Codes
Scooba will tell you something is wrong
by turning on the Service light and
playing a 4-tone alarm followed by a
number of beeps.
Refer to the table below to resolve
Scooba's problem. If the problem persists, visit www.irobot.com/support.
number of Beeps
after alarm
1
2
3
4
5
22
iRobot Scooba Owner's Manual
what To Do
Inspect Scooba's wheels. Push each wheel up and
down, place the robot back on the floor and press Clean.
Ensure that the front wheel can spin freely. Lightly push
the wheel up and down. The front wheel can easily be
removed, cleaned, and replaced.
Tap the bumper to ensure that it moves in and out.
Visually inspect the bumper edges for debris.
Clean cliff sensors with a cotton swab (see page 6 for
sensor location). The cliff sensors are located in the
bumper and are accessed by turning Scooba over.
Inspect Scooba's drive wheels. Spin the wheels by
hand and confirm that they offer some resistance. If
it does not, or if it's stuck and you can't dislodge the
obstruction, contact iRobot customer care.
likely Cause
Pump malfunction
Vacuum malfunction
Battery failure
Charger has failed
Battery is too hot
what To Do
Contact iRobot customer care.
Contact iRobot customer care.
Contact iRobot customer care.
Contact iRobot customer care.
Make sure Scooba was not recently filled with hot
water or charged in a hot place. Wait for Scooba
and battery to cool down and try again.