Table of Contents
Advertisement
= 3-byte command character string.
CMD
These commands are shown in the table in
section 6.4, page 7-2.
= End of transmission = 03h
ETX
Example command:
This turns on Unit 6 in Group 0.
✎
Note: Valid data packets must start with STX and
end with ETX, and the time from STX to ETX
Start of transmission
STX
1 byte
06 PON #
RS232 command structure
Group and Unit
Identification
IDT
2 bytes
must be less than one second.
The ID number for each display is set with the
remote control. Press the
open a menu where you can highlight either
number with the up-down buttons and change it
with the right-left buttons.
Monitor ID
Group 0
Command
CMD
3 bytes
button. This will
ID
End of transmission
ETX
1 byte
4 - 3
Advertisement
Table of Contents
