Table of Contents
Advertisement
3.6 Some Additional Controls
Two of these controls have exclusive buttons and don't appear in any other menu. More special
controls are described in the next section about Misc(ellaneous) Controls.
is a special button on the remote,
MON SEL
and it means Monitor Select. It is used to
turn off the display's ability to respond to all
other remote control commands. When you
try to control one display with the remote, it
sometimes happens that the neighboring
displays respond to the IR signals, too, espe-
cially if you are some distance from the
units. Infra-red radiation is not focused like
a laser beam; it spreads out.
To handle this situation, use
) on all the units you don't want to
ENTER
control. This prevents these units from
responding to all remote commands except
another
command, which opens this
MON SEL
menu again.
In some environments there is stray infra-red
radiation which can cause the units to mis-
behave. Use
MON SEL
has no effect on the reception of RS232
commands.
is another special button, a command which
ID
does not appear in the main menu. This dis-
plays the unit's Group ID and Unit ID num-
bers. In this menu, you set the Group and Unit
ID numbers with the left and right arrow keys.
Monitor ID
Group
Unit
The Monitor ID menu is
accessible only from the special
ID button on the remote.
The two ID settings identify the display unit
for RS232 commands. Group and Unit are hex
numbers ranging from 0 to F (0 to 15 decimal).
Normally, all displays in one video wall are set
3 - 36
(then
MON SEL
to counteract this.
MON SEL
0
0
wit the same Group number, and the Unit
numbers start with 0 at the upper left corner,
increase to the right and down, like reading in
western cultures, ending with the highest
number in the lower right corner.
To change the Group and Unit numbers,
press
on the remote control, and highlight
ID
either number. Then use the left/right arrow
buttons to change it.
The ID values are saved and recalled when
you Save and Recall Settings (see page 3-26).
These numbers identify the unit for RS232
commands. Also, the Unit ID setting delays the
panel turn-on by one second times the Unit ID
number.
About, the bottom item in the main menu,
opens a general information screen giving the
name and address of the manufacturer and
some factory information about the firmware
version.
Clarity Visual Systems
9025 SW Hillman Court
Suite 3122
Wilsonville, OR 97070
USA
Tel (503) 570-0700
Web www.ClarityVisual.com
Project: 573-0800-00
Version: Rev A
Build: 0675
Open the main menu, then highlight About and
press ENTER to see the About menu.
Curtain sets the screen to black. Incoming
images are blocked. It is essentially the same as
Advertisement
Table of Contents
