AEG SANTO Operating Instructions Manual page 13

2. Unscrew the centre door bear-
ing:
Open the fridge and freezer
doors. Undo the screws far
enough to be able to take the
top door bearing bolt out of
the freezer door. Close the
freezer door. Remove the door
bearing bolt from the bottom
of the fridge door and close
the fridge door.
Caution! Take care when
removing the centre door bear-
ing that the doors do not fall
down.
Remove the centre door bear-
ing; remove the doors and lay
them carefully on the floor.
3. Unscrew the upper and lower
door bearing bolts, transfer,
and screw them onto the
opposite side.
4. Remove the plastic covers for
the centre door bearing and
insert them on the opposite side.
5. Transfer the self-closing system:
Unscrew the self-closing system on the right of the freezer door and
screw it onto the opposite side of the freezer door.
Unscrew the self-closing system on the right of the fridge door and
screw it onto the opposite side of the fridge door.
6. Fit the freezer door into the lower door bearing bolt and insert the cen-
tre door bearing above into the freezer door.
7. Insert the fridge door into the upper door bearing bolt. Pull both doors
forwards until the centre door bearing can be inserted below into the
fridge door.
8. Position the doors and centre door bearing against the housing and
screw the centre door bearing tight with each door open.
9. Fit the base mask with the freezer door open. To do this insert the two
lower fins of the base mask in the housing and press the basemask
against the housing until the upper catches of the basemask snap into
position in the housing. To do this, press the catches downwards.
Reversing The Door
47